1、Simple snowflake cake

A simple, but sophisticated decoration for a homemade or bought cake - it'll only take half an hour

Simple snowflake cake recipe

Ingredients

  • 1 x 20cm round Christmas cake, homemade (see 'Goes well with' recipe) or bought
  • 1 tbsp clear honey
  • 300g marzipan
  • 2 egg whites
  • about 500g sifted icing sugar
  • 1 tsp glycerine
  • silver dragees
  • approx 65cm wide silver ribbon (available from cake decorating suppliers or stationers)
  • approx 65cm clear snowflake ribbon (available from Paperchase)

Method

Roll out the marzipan, then trim to fit the top of the cake, using the cake itself or the cake tin as a template. Lay the marzipan on top of the cake, then press down lightly.
  • Lightly beat the egg whites with a fork, just to break them up, then gradually beat in the sifted icing sugar until you have an icing that forms soft peaks. Beat in the glycerine to stop the icing from getting too hard. Spread and thickly swirl the icing over the marzipan, then scatter with silver dragees. Decorate by wrapping round a silver ribbon and then the clear snowflake ribbon.

  • https://www.truecookbook.com/recipe/simple-snowflake-cake-6515/

    2、Simple elegance wedding cake

    To make a three-tier wedding cake, all you need to do is multiply basic cake mixtures and icings, and take your time
    Simple elegance wedding cake recipe

    Ingredients

    • 5 x ingredients for Easy vanilla cake (see 'Goes well with' recipe below)
    • 5 x ingredients for Basic vanilla buttercream (see recipe below)
    • 340g/12oz jar strawberry jam, optional (I used Tiptree Strawberry & Champagne)
    • 340g/12oz jar apricot jam, warmed and sieved
    • 4kg white ready-to-roll icing (I used Regalice)
    • 15cm, 23cm and 30cm thin round cake boards
    • 40cm thick round cake board
    • cocktail sticks
    • palette knife
    • a roll of baking parchment
    • a flat baking sheet or cake lifter
    • icing sugar, for rolling out
    • string, for measuring
    • 8 x long plastic dowels
    • kitchen scissors
    • 3½ m x 1½ cm white satin ribbon
    • tube of UHU glue, or similar
    • 12cm and 15cm polystyrene cake dummies
    • 18-gauge floristry wire, cut into about 20 x 10cm lengths
    • 15-20 white and pale green hydrangea heads (get some smaller, some larger, if you can); your florist can advise
    • 40cm, 30cm and 18cm cake boxes with lids, if you're transporting the cake

    Method

    1. MAKING THE CAKES: Make the basic Easy vanilla cake recipe (see 'Goes well with'), following the instructions below for each tier, then cool and drench with the syrup. The cakes can be frozen ahead, without icing. However, if you bake them three days before the wedding, the cake will be fine until the big day.
    2. For the bottom tier, triple the quantities for the basic cake mix, then spoon into a ready-lined deep round 30cm cake tin. Bake for 2 hrs 15 mins on the middle shelf until risen and cooked through as before. While this cooks, make up a quadruple batch of the syrup - this will be enough for all three cakes. Cool and drench the cake with syrup as before.
    3. For the middle and top tiers, double the quantities for the basic cake mix, then spoon it into ready-lined 15cm and 23cm cake tins, filling each to about two-thirds full. Bake them together on the middle shelf, taking the small cake out after 1 hr 15 mins, and leaving the larger cake to cook for 1 hr 30 mins in total. If you know that your oven has hot spots, quickly move the cakes around after 50 mins. Cool and drench with syrup as before.
    4. LAYER AND COVER THE CAKES: Make the buttercream as in the basic recipe. You will need 5 x basic quantity - this is a lot, so split your weighed-out quantities in two before you start mixing. You may have some left over, but better too much than too little. Weigh out the buttercream - you will need approximately 400g for the 15cm cake, 600g for the 23cm cake and 1.3kg for the 30cm cake. Spread a little buttercream over the 15cm cake board. Level the top of the cake if you need to, then upturn the 15cm cake onto it. Split into three using a bread knife. I like to mark the front of the cake on each layer before lifting it off, using toothpicks, so I can reassemble it in exactly the right way. Take the top third off first (what was the bottom of the cake) and set aside. Carefully cut the middle layer and set that aside, too. A flat baking sheet or cake lifter can be very helpful here to slide the cake layers off and then back onto each other.
    5. Spread a layer of buttercream over the cake on the board. Return the middle layer, lining up the toothpick markings, then spread another layer of buttercream on top. Add a little jam if you like, dotting it over, then spreading evenly. Top with the final piece of cake, then dust off any crumbs on or around the cake. Now brush the whole cake with a thin layer of apricot jam. This should stop you getting too many crumbs in the buttercream. Sit the whole cake on a large sheet of baking parchment.
    6. Spread the rest of the buttercream over, starting with the top, then smooth and paddle it around the sides and down to the board. Repeat the whole process with the remaining cakes, using the corresponding boards and the different quantities of buttercream. The cakes are now ready to be iced. You can leave them overnight if needed, loosely covered with cling film.
    7. COVERING THE CAKE WITH ICING: You will need about 500g icing for the 15cm cake, 1kg for the 23cm cake and 1.7kg for the 30cm cake. Dust the work surface with icing sugar, knead the icing until pliable, then use your rolling pin to roll it into a circle large enough to cover the sides and top of the cake, with a little left over. Use string to check the size. Use your rolling pin to help you lift the icing over the cake.
    8. Smooth the icing around the cake with your hands, easing it over the edges and down to the board. Then trim off the excess with a sharp knife, flush with the bottom of the cake board. Smooth any marks with the flats of your hands, buffing the icing to a slight shine.
    9. Once you've iced all the cakes, cover the thick base board. Lightly brush with cooled boiled water, then lay the icing over. Trim to the edge of the board with a knife (I tend to do this like I would a pie crust, holding the board in my left hand, and knife in my right), then leave the board and the cakes to dry overnight.
    10. STACKING THE CAKES: Dowels, which are basically plastic sticks, provide stability and strength to tiered cakes, and polystyrene blocks allow you to add a 'floating' layer of flowers. By measuring and cutting the dowels to the same length as the polystyrene, you'll provide an even platform for the next cake to sit on, even if the cake below is a bit wonky.
    11. Sit the 15cm dummy centrally on top of the biggest cake. Insert four of the dowels into the cake, around the outside of the dummy, in a square shape. Push them right down until they meet the cake board. Mark with a pen where the top of the dummy comes to.
    12. Carefully pull out the dowels; then, using scissors, score around each dowel where you marked it. Snap the plastic cleanly. Re-insert the dowels in their original holes, rounded end down. Repeat the process with the 23cm cake and the 12cm dummy.
    13. Position the biggest cake in the middle of the covered board. Run a thin line of glue around the base board and fix the ribbon around it. Fix the ribbon around each cake, using a spot of the glue on the ribbon to secure it to itself. If you're moving the cake to a venue, put the cakes into their boxes now. Make a little kit to take with you - glue, scissors, etc - just in case you have to re-do anything.
    14. ON THE DAY - STACKING AND DECORATING THE CAKE WITH FLOWERS: I used hydrangeas - they're beautiful, in season and you can achieve a dramatic effect with relatively few blooms. On the day, save putting the flowers on the cake until as late as you reasonably can. Cut the stems of the hydrangeas to about 2-3cm. Split your least-favourite bloom into smaller pieces - this will help you fill any awkward gaps later. Make sure you save one beautiful bloom for the top.
    15. Insert a length of floristry wire into each stem (or wind it around the stem), leaving a spike of wire about 3cm long. Push this into the polystyrene dummy. Repeat until the two dummies are surrounded with a halo of flowers. The bottom cake should be in its permanent position now - out of direct light and away from any radiators. Lift the 23cm cake onto the bottom polystrene dummy, taking care not to squash any petals, then repeat with the top cake. Fill any gaps with the broken-up flower head you reserved earlier. Sit the final bloom on top of the cake, and you're done!
    16. CUTTING THE CAKE: Cut the cake across, in a grid, rather than into wedges. You should be able to get 50 servings from the large cake, 30 from the middle and 12 from the top, when cut into 2.5 x 5cm pieces.

    3、Sparkling snowflake cake

    This stylish, shimmering cake is ideal if you've had some practice at cake decorating before
    Sparkling snowflake cake recipe

    Ingredients

    • 18-23cm fruit cake (see link below) covered with marzipan and ready-to-roll white icing
    • 250g white ready-to-roll icing
    • 1 quantity soft royal icing
    • edible silver lustre, edible silver balls and edible sparkles, fine writing tube and small piping bag

    Method

    1. Knead the ready-to-roll icing until smooth, then roll out to approx 1cm thickness. Using snowflake cutters of various sizes, stamp out 3 snowflake shapes. Lay the snowflakes on baking parchment on a flat surface and leave overnight to harden. Keep any trimmings and wrap up in cling film.
    2. Next day, make the royal icing. Drop a writing tube into a piping bag and spoon in a third of the icing. Spread the rest around the base of the cake to create a snowdrift effect. Pipe snowflake outlines over the cut-out snowflake shapes and pipe snowflakes all over the surface of the cake in different sizes and designs. Leave for 1 hr until the icing has hardened slightly, then sprinkle silver lustre over the cake, snowdrift and snowflakes.
    3. Using the leftover ready-to-roll white icing, mould thimble-sized supports for your snowflakes to lean against. Position the snowflakes on the top of the cake. Finally, fix the silver balls to the icing with a little more of the royal icing. Finish by scattering sparkles over.

    4、Simple snow sparkle cake

    This crunchy, sugar-snow topping is an easy way to transform a humble fruitcake into a celebration centrepiece
    Simple snow sparkle cake recipe

    Ingredients

    • 400g white sugar cube
    • 100g preserving sugar
    • 3 tbsp edible pearly balls
    • 1 egg white, lightly whisked
    • edible silver glitter
    • 1 20cm-wide Christmas cake (see 'goes well with')
    • ribbons
    • shop-bought decorations (optional)

    Method

    1. Once the cake has been removed from the oven, increase the heat to 200C/180C fan/gas 6. Leave the cake in its tin. Put the sugar cubes in a large bowl and crush with the end of a rolling pin to a sugary rubble. Mix in the preserving sugar, pearly balls and egg white – it should have the texture of wet sand. Tip the mixture on top of the cake and level the surface. Bake the cake for 5 mins to set the sugary crust, then remove and leave to cool.
    2. Once completely cooled, remove from the tin and peel off the baking parchment. Sprinkle the top with edible glitter, tie ribbons around the side and decorate with your favourite figurines, if you like.

    More...